Power On Delay. When a device receives a PowerOn command, it takes a certain amount of time to "warm up" the device and resume normal operation. For most devices this happens very quickly, but for some devices, such as televisions and receivers, it can take up to 3000 milliseconds (three seconds).
Inter-key Delay. When a device receives an infrared command the device is considered"busy" while it processes the command. The amount of time required before the device will respond to another command is known as the inter-key delay, and normally ranges from zero to 300 milliseconds. Devices with long inter-key delays take longer to respond to multiple infrared commands (e.g., when changing television channels).
Input Delay. When a device switches inputs (e.g. goes from Video 1 to Video 2) the device is considered "busy" while it processes the command. The amount of time required before the device will respond to another switch input command is known as the input delay, and normally ranges from 500 to 3000 milliseconds. Devices with long input delays take longer to change inputs.
Inter-Device Delay. When an infrared command is sent for a particular device, each device in your system will receive the command, but only one will respond to it. The other devices will ignore the infrared command. Sometimes, when this happens, a device will ignore the infrared signal and then stop accepting infrared commands for a period of time. This period of time is known as the inter-device delay. During this time no infrared signals are generated by the remote. In rare cases this delay can be several seconds.
I did some more testing with the following script:
When the blink rate is set to 450 and below it results in 3 x down.
When the blink rate is set to 500 it results in variations of 2 x down and 1 x down.
When the blink rate is set to 550 and above it results in 1 x down.
Unchecking "Block Signal on Tray Blink" did not change the results.
I tested using the same method all the way up to a 2000 ms tray blink rate with "Opt("SendKeyDelay", 2000)", all with the same results.
Keylonta wrote:Do you have the same issue at your end with HID?
Users browsing this forum: No registered users and 1 guest